Frama-C-discuss mailing list archives

This page gathers the archives of the old Frama-C-discuss archives, that was hosted by Inria's gforge before its demise at the end of 2020. To search for mails newer than September 2020, please visit the page of the new mailing list on Renater.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Frama-c-discuss] adding new provers to why3

Hello Xiao-lei,

2013/11/8 Xiao-lei Cui <x_cui at hotmail.com>:
>    I am trying to add Simplify-1.5.4 to why3 prover list.
>    I copied Simplify-1.5.4.linux to /usr/sbin/ directory, and run the
> commands as it follows:

The prover should be in your regular user PATH. I doubt /usr/sbin/ is
in your PATH (it is a special path for administrators). I would put
the Simplify binary into /usr/local/bin/. The general habit is to
never put anything outside /usr/local/.

> cuix at berkhoff:~/Downloads/why3-0.81$ why3config --add-prover simplify
> /usr/sbin/Simplify-1.5.4.linux
> Found prover Simplify version 1.5.4 (it is an old version that is less
> tested than the current one).
> Save config to /home/cuix/.why3.conf

What print "why3 --list-provers" after that step?

> cuix at berkhoff:~/Downloads/why3-0.81$ why3config --detect-provers
> Found prover Alt-Ergo version 0.93 (it is an old version that is less tested
> than the current one).
> Found prover CVC3 version 2.4.1, Ok.
> Found prover Coq version 8.3pl4, Ok.
> 3 provers detected and 0 provers detected with unsupported version
> Save config to /home/cuix/.why3.conf

Option --detect-provers re-initialize your /home/cuix/.why3.conf
configuration file, therefore I guess your previous --add-prover
configuration is lost.

Best regards,
david