Frama-C-discuss mailing list archives

This page gathers the archives of the old Frama-C-discuss archives, that was hosted by Inria's gforge before its demise at the end of 2020. To search for mails newer than September 2020, please visit the page of the new mailing list on Renater.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Frama-c-discuss] adding new provers to why3

  • Subject: [Frama-c-discuss] adding new provers to why3
  • From: x_cui at hotmail.com (Xiao-lei Cui)
  • Date: Thu, 7 Nov 2013 22:24:41 -0500
hi all,
   I am trying to add Simplify-1.5.4 to why3 prover list. 
   I copied Simplify-1.5.4.linux to /usr/sbin/ directory, and run the commands as it follows:

cuix at berkhoff:~/Downloads/why3-0.81$ why3config --add-prover simplify  /usr/sbin/Simplify-1.5.4.linux 
Found prover Simplify version 1.5.4 (it is an old version that is less tested than the current one).
Save config to /home/cuix/.why3.conf

cuix at berkhoff:~/Downloads/why3-0.81$ why3config --detect-provers
Found prover Alt-Ergo version 0.93 (it is an old version that is less tested than the current one).
Found prover CVC3 version 2.4.1, Ok.
Found prover Coq version 8.3pl4, Ok.
3 provers detected and 0 provers detected with unsupported version
Save config to /home/cuix/.why3.conf

   Simplify1.5.4 is not detected by why3 afterwards. Simplify1.5.4 is only shipped as binary. I might missed some commands though.   Any suggestions on fixing this problem?

   thanks!

xiaolei 

 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.gforge.inria.fr/pipermail/frama-c-discuss/attachments/20131107/b8f15687/attachment.html>